If you allow multiple builds to update the derived-file cache directory simultaneously, two builds that occur at the same time can sometimes start "racing" with one another to build the same files in the same order. If, for example, you are linking multiple files into an executable program:

Program('prog', ['f1.c', 'f2.c', 'f3.c', 'f4.c', 'f5.c'])
       

SCons will normally build the input object files on which the program depends in their normal, sorted order:

% scons -Q
cc -o f5.o -c f5.c
cc -o f3.o -c f3.c
cc -o f1.o -c f1.c
cc -o f2.o -c f2.c
cc -o f4.o -c f4.c
cc -o prog f1.o f2.o f3.o f4.o f5.o

But if two such builds take place simultaneously, they may each look in the cache at nearly the same time and both decide that f1.o must be rebuilt and pushed into the derived-file cache directory, then both decide that f2.o must be rebuilt (and pushed into the derived-file cache directory), then both decide that f3.o must be rebuilt... This won't cause any actual build problems--both builds will succeed, generate correct output files, and populate the cache--but it does represent wasted effort.

To alleviate such contention for the cache, you can use the --random command-line option to tell SCons to build dependencies in a random order:

  % scons -Q --random
  cc -o f3.o -c f3.c
  cc -o f1.o -c f1.c
  cc -o f5.o -c f5.c
  cc -o f2.o -c f2.c
  cc -o f4.o -c f4.c
  cc -o prog f1.o f2.o f3.o f4.o f5.o
    

Multiple builds using the --random option will usually build their dependencies in different, random orders, which minimizes the chances for a lot of contention for same-named files in the derived-file cache directory. Multiple simultaneous builds might still race to try to build the same target file on occasion, but long sequences of inefficient contention should be rare.

Note, of course, the --random option will cause the output that SCons prints to be inconsistent from invocation to invocation, which may be an issue when trying to compare output from different build runs.

If you want to make sure dependencies will be built in a random order without having to specify the --random on very command line, you can use the SetOption function to set the random option within any SConscript file:

SetOption('random', 1)
Program('prog', ['f1.c', 'f2.c', 'f3.c', 'f4.c', 'f5.c'])